Modern Navigation, Properly Installed
Marine electronics are only as reliable as their installation. We run clean cable paths, terminate connectors to manufacturer spec, and calibrate every sensor so your helm data is accurate from day one.
What We Install
- Chartplotters & MFDs — Garmin, Simrad, Raymarine, Furuno, Lowrance
- Radar — Open-array and dome units with proper mounting and interference shielding
- Fish finders — Chirp, side-scan, and down-scan transducer placement optimized for hull type
- Communication — VHF/DSC radios, satellite phones, AIS transponders
- Autopilot — Hydraulic and electronic drive units with compass calibration
Network Integration
Most modern helms run on an NMEA 2000 backbone. We design and install the bus from scratch or extend an existing network, ensuring proper termination resistors and cable routing away from interference sources.
Troubleshooting
Intermittent GPS dropouts, phantom depth readings, or garbled AIS data usually trace back to a wiring fault or grounding issue. We carry network analyzers that pinpoint the problem in minutes.